Xerox 8830 Copier User Manual


 
XEROX WIDE FORMAT COPY SYSTEM Getting to know the WIDE FORMAT COPY SYSTEM 21
The Previous key highlights the previous item in a displayed list.
Next
The Next key highlights the following item in a displayed list.
Enter
The Enter key either confirms the selection of the currently highlighted
item or confirms an entered numeric value.
Exit
The Exit key cancels a selection operation and returns you to a previous
screen. It has other effects, depending upon the specific situation, that
are explained later.
Mode
The Mode key is a valid selection only when READY is displayed on the
screen. This key is used to switch between the READY TO COPY mode
and the READY TO SCAN mode. The SCAN mode can be entered only
if the Scan-to-Net feature key is loaded.
Below are examples of the READY screen in COPY and SCAN modes.
READY TO COPY
INSERT DOCUMENT
A
UTO
1
100.0 %
Ready to Copy Screen
READY TO SCAN
INSERT DOCUMENT
400
TIFF/CCITTG4
1
1 BIT
Ready to Scan Screen
In the COPY mode, the scanned image or set of images is printed on the
Printer and then deleted from the hard disk.
In the SCAN mode, the scanned image or set of images is stored on the
hard disk for later retrieval over a network by a client running on a
remotely located device. Scanned images can also be transferred to
four remote FTP destinations from the Samples Mode screen. Refer to
the “Scanning to the Network” section for more information about the
SCAN mode.
NOTE: The SCAN mode is an optional feature that is enabled by
installing the Scan-to-Net feature key. Contact your XEROX
representative for ordering information.