Xerox 8830 Copier User Manual


 
24 Getting to know the WIDE FORMAT COPY SYSTEM XEROX WIDE FORMAT COPY SYSTEM
y Xerox FreeFlow Accxes Controller Service Manual for YKE/
YKE-N
Powering On the WIDE FORMAT
COPY SYSTEM
To power on the XEROX WIDE FORMAT COPY SYSTEMS, you first
must switch on the Scan System and wait for 30 seconds or check that a
“P” is displayed on the status LED in the back of the Scan System. Then
switch on the Printer, then the Controller.
Follow the instructions provided in this section for your system.
For all controllers except the YKE controller and the YKE-N controller,
when the WIDE FORMAT SCAN SYSTEM is present, the DDS
parameter must be set to Enabled in order to enable the COPY/SCAN
functionality of the scanner. Go to the Web Print Management Tool.
Select Configuration > Printer > Printer Setup > DDS Enabled. Be sure
that the DDS Enabled checkbox is selected. If the DDS Enabled
checkbox is not selected, then the COPY/SCAN functionality will be
disabled.
The default for this parameter is disabled. You must ensure that it is set
to Enabled when powering on the XEROX WIDE FORMAT SCAN
SYSTEM for the first time. After setting the DDS parameter, wait 30
seconds, and then power the system off then on. Once you enable this
parameter, it will remain enabled (even following future software
upgrades).
For the XEROX WIDE FORMAT COPY SYSTEM 510 Series or 8825,
8830, and 8850, you can set this parameter from either the
CONTROLLER CONFIGURATION screen of the Printer Control Panel or
on the Web Print Management Tool. For the XEROX WIDE FORMAT
COPY SYSTEM 6030/6050, 721P, and 6204, you can only set this
parameter from the Web Print Management Tool, (Configuration >
Printer > Printer Setup > DDS Enabled).
To switch on the Scan System, press the Power On/Off Switch on the
back of the Scan System to the On (I) position as shown below. Wait for
30 seconds or until a P is displayed on the status LED.
Initial power-on
Switching on the
Scan System