Xerox 8830 Copier User Manual


 
XEROX WIDE FORMAT COPY SYSTEM Making copies 49
Making copies
Making copies
When the Graphical Display indicates READY TO COPY, the WIDE
FORMAT COPY SYSTEM is ready to make copies.
Several settings are available for controlling how the Scan System starts
and finishes a scan. These settings are accessible from the SCANNER
CONTROL option of the CONFIGURATION menu.
SCANNER CONTROL
DOCUMENT RETURN:
AUTOSCAN
MODE:
FRONT
AUTOWIDTH / AUTOCENTER
9
Scanner Control Screen
When making a copy, you need to be aware of these settings. If any of
these settings have been changed from the default settings, the Scan
System may not operate according to your expectations.
Below is a brief summary of the scan control settings. For complete
information about these settings, refer to “Scan System Control” in the
“Main Menu” section of this manual.
AUTOSCAN
AUTOSCAN enabled is the default setting. Normally, the AUTOSCAN
mode is enabled. When it is enabled, the Scan System automatically
begins the scanning of a document when the document is inserted. If
AUTOSCAN is disabled, the Scan System transports the document to
the starting position and then waits for you to press the Start key before
beginning the scan.
DOCUMENT RETURN
FRONT is the default setting. When the DOCUMENT RETURN feature
is set to FRONT, the Scan System returns the document to the front or
READY position at the completion of the scan. When the DOCUMENT
RETURN feature is set to REAR, the Scan System delivers the
document to the rear Stacker at the completion of the scan.
Controlling the scan