Xerox 8830 Copier User Manual


 
XEROX WIDE FORMAT COPY SYSTEM Special features keys 73
DON’T CARE is the factory default setting. The settings are dependent
on the finisher.
OUTPUT BIN
OUTPUT BIN: BYPASS
Output Bin Screen
Sets Build key
The Sets Build mode allows you to scan a series of images and build an
electronically collated set. Once the set is built, one or more collated
copies can be printed.
NOTE: The Sets Build mode is not available unless the WIDE FORMAT
COPY SYSTEM is in the COPY mode.
NOTE: Any of the finishing options can be changed during a Sets Build
job. The option(s) must be changed before the document to be copied is
inserted.
In Sets Build mode, documents of C (A2) size, and larger, are normally
delivered to the rear of the Scan System after the scan. If the
DOCUMENT RETURN parameter is set to REAR, then all documents
are delivered to the rear after scanning. The WIDE FORMAT SCAN
SYSTEM is equipped with a document catching device, called the
Stacker, to receive these documents. Refer to “Scan System Control” in
the “Main Menu” section of this manual for further information about the
DOCUMENT RETURN parameter.
To build a collated set:
1. Press the
Sets Build key. The Sets Build indicator lamp
illuminates and the SETS BUILD screen is displayed. This
screen enables you to select the desired collation method, to
select whether or not to print checkplots, and to begin the
accumulation of the documents to create the set.
SETS BUILD
COLLATION: FORWARD
9 CHECKPLOT
Sets Build Screen
2. Press the
Previous or the Next key to select FORWARD or
REVERSE collation.
Preparing to build the
set
Building and printing
the set