Filter
Top Products
Connections and Installation
Xerox FS 5250, User’s Guide
- 13 -
6. Connections and Installation of
the Xerox FS 5250
This chapter starts with an overview of the functionality of the rear panel.
Then follows a description of how you connect the Xerox FS 5250 box to a
printer and finally how to connect it to a System.
NOTE:
Before you start the installation, make sure that you set the address
switch and the desired emulation. See the description in the section
"Emulation".
6.1. The Rear Panel
RS232
12-18 VDC.
0.7A
PARALLEL IN PARALLEL OUTADDR
+ --
B
A
T
6
5
4
3
2
0
1
A = PCL, B = XES
Xerox FS 5250 Rear Panel
PARALLEL OUT
The parallel output port can be connected to the parallel/Centronics in put
port on the target printer (parallel out cable is supplied with the kit).
PARALLEL IN
The parallel input port can be connected to the parallel/Centronics out put on
a PC or similar source which enables it to share the printer with the host. For
this connection you need a cable ending in a 25-pole D-Sub connector
(order no. 999022 030).
SERIAL IN/OUT
The serial port can be configured either as input or as output. Default
configuration is input.