Filter
Top Products
Function Selection via the Line
Xerox FS 5250, User’s Guide
- 30 -
8.5. Defining a Permanent Escape Character
The paragraph "Defining a Temporary Escape Char acter", only described
the saving of the escape character in the temporary memory .
If you wish to define and save a permanent escape character in the printer,
you will have to use Function 48, Select Perma nent Escape Character, and
immediately save the settings in the permanent memory . See the description
of Y48 in either XES or PCL.
NOTE:
If the character used in Function 48, Select Permanent Escape
Character, is different from the one specified as temporary escape
character, the latest specified character will take precedence immedi-
ately.
An example of the commands defining the permanent escape charac ter is
shown below.
PCL XES
&&??% &&??%
%Y48,08% %Y48,4C%
>X1 >X1
Syntaxes of the command strings defining the permanent escape character to be 08
(the character ">") instead of the temporary escape character "%".
8.6. Removing Permanent Escape Character
If you wish to remove the permanent escape character , you will have to
follow the procedure below:
1. Set Function 48, Select Permanent Escape Character, to "00" (No
escape character).
2. Define a new temporary escape character as described in "Defining a
Temporary Escape Character".
3. Save the settings using the command "<ESC> X1".
Examples of these commands are shown below.