Filter
Top Products
Connections and Installation
Xerox FS 5250, User’s Guide
- 19 -
NOTE:
The device address (n2) must be different from the address switch
setting or this command will only modify the primary printer emulation
without creating a secondary.
One non-IPDS and one IPDS emulation can be defined.
The secondary printer device will be deleted if you attempt to configure two
similar devices (e.g. two non-IPDS devices) or if Y37 is used without
specifying n2.
For this change to become effective, you must turn power to the converter off
for approx. 10 seconds and then back on.
Non-IPDS as primary emulation
If the primary printer emulation (set via the address switch) is set to non-
IPDS, you can set the second emulation via the twinax port activating Y37.
E.g.
Primary emulation: non-IPDS (set via address switch)
Second emulation: %Y37,*IPDS,6%%X1
You have now a non-IPDS primary emulation, and a second IPDS emulation
answering on device address 6.
As an alternative setup, you can also use the Centronics port activating
function Y249, Enter Engineering Mode.
E.g.:
Primary emulation: non-IPDS (set via address switch)
Second emulation: %Y249, password%
2)
%Y37,*IPDS,5%%X1
IPDS as primary emulation
If the primary emulation is set to IPDS (set via the address switch) the only
way to set a second emulation is through the Centronics port enabling
function Y249, Enter Engineering Mode. You must still set function Y37 to
the desired emulation.
E.g.
Primary emulation: IPDS (set via address switch)
Second emulation: %Y249,password%
%Y37,3812,1%%X1
2
As the password is sensitive information, please contact point of purchase for details