Filter
Top Products
Connections and Installation
Xerox FS 5250, User’s Guide
- 18 -
6.2.3 Address Setting
via the address switch
To select the desired address using the rotary address switch follow these
steps. The steps 1 through 4 are mandatory, whereas the steps 4 through 6
are optional.
1. Power off the Xerox FS 5250.
2. Disconnect the T-cable
3. Set the address switch to the desired address. The options are 0-6.
4. Power on the Xerox FS 5250. The desired address will be set at this
point of time.
5. To verify the address turn the switch to the “T” position to print the
current settings printout.
6. Turn the switch back to the desired address number.
The default configuration of the Xerox FS 5250 can be used for most
application programs and uses. You should only change the address
and the emulation if necessary. Change only the rest of the settings if
you have special requirements.
6.2.4 Dual Printer Emulation
PCL only
With IPDS support in the Xerox FS 5250, you have the option of configuring
a second emulation on a different address.
You select a second emulation via the line in function Y37 and both
parameters (n1 and n2) in Y37 must be specified.
The parameter n1 sets the printer emulation. Note that you will have to
physically write the IBM printer number of the desired emulation. For IPDS,
you must write: *IPDS. Parameter n2 specifies the device address.