Filter
Top Products
82
Phaser 7700 Color Printer
Specifications
SECTION 6 - ACCIDENTAL RELEASE MEASURES
SPILL OR LEAK: Sweep up or vacuum spilled materials and carefully transfer
into sealable waste container. Sweep slowly to minimize generation of dust
during clean up. If a vacuum is used, the motor must be rated as dust tight. A
conductive hose bonded to the machine should be used to reduce static
buildup. Clean up residue if necessary with soap and cold water. Wash or dry
clean garments after removing loose toner.
SECTION 7 - HANDLING AND STORAGE
HANDLING: No special precautions, when used as intended.
STORAGE: Avoid high temperatures.
SECTION 8 - EXPOSURE CONTROL - PERSONAL PROTECTION
No special personal protection indicated, when used as intended in Xerox
Phaser® color printers.
THRESHOLD LIMIT VALUE (TLV): 10 mg/m
3
(total dust)
PERMISSIBLE EXPOSURE LIMIT (PEL): 15 mg/m
3
(total dust); 5 mg/m
3
(respirable dust)
SHORT TERM EXPOSURE LIMIT (STEL): None established
CEILING LIMIT: None established
XEROX EXPOSURE LIMIT (XEL): 2.5 mg/m
3
(total dust); 0.4 mg/m
3
(respirable dust)
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE/ODOR: Black, blue, red, or yellow powders/faint odor
BOILING POINT: Not applicable
SOLUBILITY IN WATER: Insoluble
EVAPORATION RATE: Not applicable
VAPOR DENSITY (Air = 1): Not applicable
VOLATILE: Not applicable
SOFTENING RANGE: Not available
MELTING POINT: Not available
SPECIFIC GRAVITY (Water = 1): Approximately 1 (toner), 5 (developer)
VAPOR PRESSURE (mm Hg): Not applicable
pH: Not applicable