Filter
Top Products
MicroBlaze Processor Reference Guide www.xilinx.com 83
UG081 (v6.0) June 1, 2006 1-800-255-7778
Instructions
R
bgt
Branch if Greater Than
Description
Branch if rA is greater than 0, to the instruction located in the offset value of rB. The target
of the branch will be the instruction at address PC + rB.
The mnemonic bgtd will set the D bit. The D bit determineswhether there is a branch delay
slot or not. If the D bit is set, it means that there is a delay slot and the instruction following
the branch (i.e. in the branch delay slot) is allowed to complete execution before executing
the target instruction. If the D bit is not set, it means that there is no delay slot, so the
instruction to be executed after the branch is the target instruction.
Pseudocode
If rA > 0 then
PC
← PC + rB
else
PC
← PC + 4
if D = 1 then
allow following instruction to complete execution
Registers Altered
• PC
Latency
1 cycle (if branch is not taken)
2 cycles (if branch is taken and the D bit is set)
3 cycles (if branch is taken and the D bit is not set)
Note
A delay slot must not be used by the following: IMM, branch, or break instructions. This
also applies to instructions causing recoverable exceptions (e.g. unalignement), when
hardware exceptions are enabled. Interrupts and external hardware breaks are deferred
until after the delay slot branch has been completed.
bgt rA, rB Branch if Greater Than
bgtd rA, rB Branch if Greater Than with Delay
1 0 0 1 1 1 D 0 1 0 0 rA rB 0 0 0 0 0 0 0 0 0 0 0
0 6 11 16 21 31