Filter
Top Products
71
MANUAL SETUP
ADVANCED
OPERATION
• Select ANGLE TO WALL OR CORNER if this unit is
installed in the corner in your listening room. Adjust
the width and length of your listening room as well as
the distance of the listening position from this unit and
the distance of the center of this unit from the left wall.
Choices for the room width and length:
2.0 m to 12.0 m
Choices for the listening position from this unit:
2.0 m to 9.0 m
Choices for the listening position from the left wall:
0.6 m to 11.4 m
When you set the INSTALLED POSITION parameter in BASIC
SETUP (see page 64) or MANUAL SETUP (see page 70), the
parameters newly set for the width and length of your listening
room are automatically set as the factory default value.
INSTALLED HEIGHT (Installed height of this unit)
Use to adjust the installed height of this unit.
Control range: 0.0 m to 3.0 m (0.0 ft to 10.0 ft)
Initial setting: 1.0 m (3.5 ft)
■ BEAM ADJUSTMENT (Beam adjustment)
Use to manually adjust the various speaker beam angles.
We recommend that you select 5 beam mode before
adjusting these parameters.
• When INSTALLED POSITION is adjusted in BASIC SETUP
(see page 64) or MANUAL SETUP (see page 70), the factory
default value is automatically set for this parameter except when
FOCAL LENGTH is set to CENTER (see page 73).
• Depending on the beam mode settings (see page 42), some
speaker positions may not be available for selection. In this
case, “– –” is displayed. When using the stereo plus 3 beam
mode, set the surround left and right signals to be output from
the front left and right speakers.
Note
Listening position
from the unit
Room length
Room width
A)SETTING PARAMETERS 2/3
12.0m
12.0m
[]/[]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
p
p
A)SETTING PARAMETERS 3/3
12.0m
[]/[]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
p
p
Room width and length
Listening position from the
unit and the left wall
Notes
0.0 m to 3.0 m
(0.0 ft to 10.0 ft)
Floor
.a)HORIZONTAL ANGLE
b)VERTICAL ANGLE
c)BEAM TRAVEL LENGTH
d)FOCAL LENGTH
e)TREBLE GAIN
[]/[]:Up/Down
[SELECT]:Enter
B)BEAM ADJUSTMENT
p
p