Filter
Top Products
83
ADJUSTING SYSTEM PARAMETERS
ADVANCED
OPERATION
4 Press / to switch between PRESET:
RESET and PRESET: CANCEL.
• Select PRESET: RESET to reset all of the current
settings.
• Select PRESET: CANCEL to cancel the resetting
procedure.
5 Press STANDBY/ON on the front panel or on
the remote control to set this unit to the
standby mode.
The new setting will be activated when you turn on
the power of this unit next time.
You can adjust the sound beam output level of each
speaker by using the test tone or the audio output being
played back in each beam mode to achieve a more true-to-
life surround sound experience.
y
If the level of a particular speaker cannot be adjusted, “– –dB”
appears in the front panel display.
■ Using the test tone
You can use the test tone feature to output a test tone from
each speaker to manually balance the speaker levels.
Use the test tone to set speaker levels so that the volume
level of each speaker is identical when heard from your
listening position.
• All the speaker levels cannot be adjusted when the stereo mode
or the target mode is selected as the beam mode (see page 44).
• FRONT L/R cannot be adjusted when the stereo plus 3 mode is
selected as the beam mode (see page 43).
1 Press TEST on the remote control.
TEST LEFT appears in the front panel display and a
test tone is output from the front left speaker.
ENTER
VOL
PRESET: RESET
VOL
PRESET: CANCEL
STANDBY/ON
or
Front panel
Remote control
Adjusting the audio balance
Notes
CH LEVEL MENU
RETURN
TEST
ENTER
SURROUND
OFF
SPORTS
0
+10
CINEMA DSP
TEST
VOL
TEST LEFT