Filter
Top Products
Doc# 27-0023UM Rev 1.0 Issued 09/04
7
INSTALLATION
SLIDE REMOVAL
With the Console sitting
on a workbench with the
front facing towards you,
press down to release the
Z-Locks on each side of the
front of the Console to slide
the side rails back.
The slide rail will reach a
stop about half way back.
This is a safety stop to
prevent the Console from
sliding out too far while
mounted to the rack.
Simultaneously press in
the safety catches on each
slide rail and slide the side
rails all the way off the back
of the Console.
On the front of the cabinet
frame, use three Phillips
screws on each side to
secure the right and left
Z-Lock mounts.
DO NOT tighten these
screws to allow for adjust-
ment of the Console within
the cabinet frame.
On the rear of the cabinet
frame, use three Phillips
screws to loosely secure
the right and left rear slide
mount to the cabinet frame.
DO NOT tighten these
screws fully at this time.
INSTALL THE SLIDES IN THE CABINET FRAME
The slides should now
be separated from the
Console.
Each slide unit includes
the slide rail, with the front
Z-lock mount and the rear
mount.
On the slide rails, using a
slot screwdriver, loosen
off the slide extension rail
screw. Repeat on each
side.