Filter
Top Products
Routine Maintenance
Clean the Snap Plate
114
11342L-001 Rev. A 105SL User Guide 6/30/06
Clean the Snap Plate
Clean the snap plate to remove label adhesive or a label that has adhered to the underside of
the snap plate.
To clean the snap plate, complete these steps:
1.
Insert a small-blade screwdriver or similar tool into the loop on the left side of the snap
plate. Lift the snap plate.
2. Repeat step 1 on the right side of the snap plate.
3. Remove the snap plate from the printer.
4. Using the swab from the Preventive Maintenance Kit (part number 47362), clean the snap
plate. In place of the Preventive Maintenance Kit, you may use a clean swab dipped in a
solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%).
Allow the solvent to evaporate.
5. To reinstall the snap plate, insert the two tabs on the bottom of the snap plate (1) into the
two slots of the media pathway (
2).
6. Slide the snap plate toward you.
7. Press down on the loops to lock the snap plate into place.
Caution • Do not bend, twist, or deform the loops in the snap plate. If the snap plate is
damaged in any way, a new one may be required for proper ribbon sensing.
2
2
1
1