Zebra Technologies 105SLTM Printer User Manual


 
161
Index
6/30/06 105SL User Guide 11342L-001 Rev. A
I
images list, 84
initialize Flash memory, 86
initialize memory card, 85
inspect for shipping damage, 17
interfaces
IEEE 1284 bidirectional parallel, 21
print servers, 22
RS-232 serial, 20
international safety organization marks, 24
IP settings
default gateway, 99
IP address, 99
protocol, 98
subnet mask, 99
L
label backing removal, 47, 55
label length maximum setting, 83
label top
printer cannot detect, 129
setting, 93
label-available sensor
when to clean, 108
labels did not print, 126
language
changing from unreadable language, 128
selection, 97
LCD error messages, 119
LCD messages
adjust LCD settings, 96
language selection, 97
Setup mode, 79
liability, ii
list settings
all settings, 85
bar codes, 84
fonts, 84
formats, 84
images, 84
network, 84
setup, 84
load factory defaults, 75
loading
ribbon, 61
long calibration, 71
lower media sensor adjustment, 67
lubrication, 108
M
MAC address, 99
mark LED setting, 96
Mark Med S. setting, 96
maximum label length setting, 83
media
continuous roll media, 26
fanfold, 26
loading, 30
media LED setting, 96
non-continuous roll media, 25
ordering, 3
setting media type, 81
types of media, 25
media and ribbon sensor calibration procedure, 88
media compartment, 13
media door, 8
media loading
Cutter mode, 57
Peel-Off mode, 38
Rewind mode, 49
Tear-Off mode, 34
media path cleaning, 108
media power up setting, 92
Media S. setting, 96
media scratch test, 27
media sensor
print sensor profile, 87
sensor sensitivity calibration, 72
media specifications, 146
memory card installation
PCMCIA memory card, 104
memory options, 143
MINUS button function, 11
N
network configuration label
printing, 78
printing using List Network command, 84
network ID setting, 90
NEXT/SAVE button function, 10
non-continuous media
described, 25
setting media type, 81
O
operating conditions, 18
Operating mode, 10
optional print servers, 22
ordering ribbon and media, 3
OUT OF MEMORY message, 121