Filter
Top Products
Printer Setup
Select a Communication Interface
22
11342L-001 Rev. A 105SL User Guide 6/30/06
Optional Ethernet Print Servers Ethernet-based print servers also are available to
connect your printer to a data source. Both wired and wireless options are available. Manuals
are available at http://www.zebra.com/manuals or on the user CD that came with your printer.
• With the ZebraNet Wireless or Wireless Plus Print Server board installed, a wireless
PCMCIA, CardBus, or Compact Flash
®
card can be used to communicate with a network.
For more information on this option, see the ZebraNet Wireless and Wireless Plus Print
Server User Guide.
• With the ZebraNet 10/100 Print Server (10/100 PS), the printer can communicate with a
10BaseT or 100BaseT network. For more information on 10/100 PS, see the ZebraNet
10/100 Print Server User and Reference Guide.
• With the ZebraNet Print Server II (PSII), the printer can communicate with a 10BaseT
network. For more information on PSII, see the PrintServer II User and Reference Guide.
Data Cable Requirements
Data cables must be fully shielded and fitted with metal or metallized connector shells.
Shielded cables and connectors are required to prevent radiation and reception of electrical
noise.
To minimize electrical noise pickup in the cable:
• Keep data cables as short as possible.
• Do not bundle the data cables tightly with the power cords.
• Do not tie the data cables to power wire conduits.
Note • The parallel connection on your printer is not operational when one of these print
servers is installed. Wireless and external wired print servers plug directly into the printer’s
parallel port. Internal print servers include a mounting bracket that covers the parallel port.
Note • Zebra printers comply with FCC Rules and Regulations, Part 15 for Class B
Equipment using fully shielded, 6.5 ft. (2 m) data cables. Use of unshielded cables may
increase radiation above the Class B limits.