Filter
Top Products
Media requirements Zebra recommends use of Zebra brand media. All media
must be direct thermal media. Media may be continuous,
die-cut, or notched. Notched media must have a notch
which is 1/4 wide 3/ long located on the left side
of the label as it feeds through the printer.
Physical size (L W H) 9.7 7.0 6.0 249 mm 179 mm
154 mm
Weight (without media) 3.35 lb 1.52 kg
Temperature
range
Operating 50° to 104° F 10° to 40° C
Storage -4° to 140° F -20° to 60° C
Relative humidity, operation and
storage
10 to 90% R.H.
Electrical External 120 or 230 VAC power supply, depending on
which model you ordered. Additional custom line cords
may also be available.
Communications
36-pin Centronics
®
-compatible parallel port and RS-232
serial port; contact your distributor for information about
ZebraNet™—ethernet connectivity for the A300.
Agency approvals •UL 544 Medical Equipment Standard Part 42.5
•CSA 22.2 No. 950 Canadian Safety Standard
•Carries the CE mark of compliance.
•IEC 950/EN 60950 International Safety Standard
•FCC Part 15 Subpart B level A Electromagnetic Radia-
tion Standard
•AAME 4.3.2 Medical Standard
•UL 1950 Domestic Safety Standard
•SOR/88-475 Canadian Electromagnetic Radiation
Standard
•EN50082-1 International Immunity Standard
•C.I.S.P.R.-22 Class B European Electromagnetic Radia-
tion Standard
Processor/memory 32-bit microcontroller, 512 kB DRAM
Power line cord •The overall length must be less than 12.5 ft (3.8 meters)
•It must be rated for at least 3 A, 250 V.
•The chassis ground (earth) MUST be connected to
assure safety and reduce electromagnetic interference.
The ground connection is handled by the third wire
(earth) in the power line cord. See Figure 7.
The AC power plug and IEC 320 connector must bear
the certification mark of at least one international safety
organization (some examples are shown in Figure 2.)
Parallel data cable For maximum reliability, use a parallel data cable no
longer than 6 ft (1.8 m).
Table 5: Specifications (Continued)
55530lr4 Page 23 Wednesday, March 26, 1997 11:18 AM