Filter
Top Products
DO NOT position printing over the Smart Card
Chip
DB-9
PINS
SMART CARD
CONTACT POINTS
DB-9
PINS
SMART CARD
CONTACT POINTS
1 C1 (Vcc) 6 C6 (Vpp)
2 C2 (Reset) 7 C7 (I/O)
3 C3 (Clock) 8 C8 (RFU)
4 C4 (RFU)
9
(GND when chip
is at station)
5 C5 (GND)
Refer to the Card Printer Programmer’s Manual for complete programming informa
-
tion.
34 980261-001 Rev.C
Orient the cards with the Smart Card Chip
at the top of the card and facing away from
the printer.
When a command to the parallel printer
interface sends a card to the Smart Card
Contact Station, the printer connects the
Smart Card Contact Station to the female
DB-9 connector on the rear of the printer.
An attached external Smart Card Programmer
can be used to program Smart Card chips.
MEDIA LOADING ORIENTATION
SMART CARD CONTACT STATION INTERFACE