Filter
Top Products
13
RW Series User Guide
Installing RW Series Batteries
Important • Batteries are shipped uncharged. Remove protective
shrink-wrap and labels from new battery packs prior to use.
1. Rotate the Belt Clip to allow access to the Battery com-
partment. This is an optional step on the RW 220.
2. Insert the battery into the printer as shown in Figure 3 or
4,
3. Rock the Battery into the printer as shown until it locks in
place.
When the battery is first installed, the Control Panel indica-
tors may briefly turn on and then go off, indicating the battery
is not fully charged (see “Charging the Battery” below and
“Operator Controls.”)
The LI72 Charger
The LI72 is a wall mounted fast charger with universal 110
to 230, 50-60 Hz. VAC input. Multiple A.C. plug configurations
comply with most international standards. This charger is in-
tended for use with the RW series printers which are equipped
with Lithium Ion (Li-ion) batteries.
continued
Figure 5: LI72 Single Charger
LI72 Charger
For best results,
remove the
Battery Pack while
charging.
Charger Jack