Filter
Top Products
39
RW Series User Guide
WLAN Module Using 802.11b/g Radio
The following section only applies when the 802.11b/g WLAN module
(With FCC ID: I28MD-ZLAN11G or FCC ID: I28MD-CXLAN11G ) is installed in a RW series printer).
Other than conditions specied elsewhere in this manual, only one of the radio options can be
installed in the printer at one time and the antenna used for these transmitters must not be co-
located or must not operate in conjunction with any other antenna.
RW Series models have the FCC ID number on a label on the back of the unit.
Caution • Use of a RW series printer with the radio module marked with FCC ID: I28MD-
ZLAN11G or FCC ID: I28MD-CXLAN11G meets the FCC requirements for radio frequency (RF)
radiation exposure in the standard body worn conguration with no minimum separation.
In this conguration, which applies whether the belt clip or shoulder strap is used, the face
of the printer from which paper is transported is facing away from the user’s body. The
standard conguration must always be used when the printer is body worn.
Industry Canada (IC) Warning
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1) This device may not cause interference.
2) This device must accept any interference, including interference that may cause
undesired operation of the device.
“Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.”