Filter
Top Products
Tear-Off Mode
Follow the instructions described in Roll Media.
Rewind Mode
The Rewind Option must be installed in the printer. To initially config-
ure the printer for this mode, follow these steps:
1. Remove the Media Rewind Plate from its storage location in front of
the printhead inside the media compartment.
2. Invert the Rewind Plate so that the lip on the attached Hook Plate points
down.
3. Insert the Hook Plate lip a short distance (1/2") into the lower opening
in the Side Plate.
4. Align the upper end of the Rewind Plate with the corresponding opening
in the Side Plate and slide the Rewind Plate in so that it stops against the
Main Frame.
5. Remove the Hook from the Take-Up Spindle Shaft.
6.RoutethemediaasshowninFigures2.5and2.6,windit1-2times
around a 3" core.
Peel-Off Mode
After loading the media, follow these steps:
1. Remove the Rewind Plate if one is present and store it on the two
mounting screws on the inside of the front panel. Align the notch or
web in the media so that the Take Label Sensor can sense a peeled la-
bel.
2.LoadmediaasshowninFigures2.5and2.6.
3. Remove the Hook from the Take-Up Spindle Shaft.
4. Remove several labels from the media backing and then wind the back-
ing 1-2 times around the Media Take-Up Spindle and reinstall the
Hook.
2-10 Zebra S-Series User’s Guide
32