Filter
Top Products
21
Introduction
ZT230 Printer Control Panel Display
8/22/12 P1048261-004
SETTINGS Menu (continued)
Items in this menu are shown in the order in which they appear when you press the RIGHT
ARROW. For more information about these settings, see Table 7, Print Settings on page 79.
Adjust the Tear-Off Position
If necessary, adjust the position of the media over the tear-off bar
after printing.
See Tear-Off Position on page 80 for more information.
Adjust the Print Width
Specify the width of the labels being used. The default value is the
maximum width for the printer, based on the printhead’s DPI
value.
See Print Width on page 81 for more information.
Select the Print Mode
Select a print mode that is compatible with your printer options.
See Print Mode on page 81 for more information.
Adjust the Label Left Position
If necessary, shift the print position horizontally on the label.
Positive numbers move the left edge of the image toward the
center of the label by the number of dots selected, while negative
numbers move the left edge of the image toward the left edge of
the label.
See Label Left Position on page 81 for more information.
▼
TEAR OFF
0
▲
▼
PRINT WIDTH
0000
▲
▼
PRINT MODE
TEAR OFF
▲
▼
LEFT POSITION
0000
▲