Zebra Technologies ZT230 Label Maker User Manual


 
83
Printer Configuration and Adjustment
Changing Printer Settings
8/22/12 P1048261-004
Calibration and Diagnostic Tools
Table 8 • Calibration and Diagnostic Tools
Print
Information
Print the specified information on one or more labels.
Accepted values:
SETTINGS—prints the printer configuration
label.
NETWORK—prints the settings for any print
server that is installed.
FORMATS—prints the available formats stored
in the printer’s RAM, Flash memory, or optional
memory card.
IMAGES—prints the available images stored in
the printer’s RAM, Flash memory, or optional
memory card.
FONTS—prints the available fonts in the printer,
including standard printer fonts plus any optional
fonts. Fonts may be stored in RAM or Flash
memory.
BARCODES—prints the available bar codes in
the printer. Bar codes may be stored in RAM or
Flash memory.
ALL—prints the previous six labels.
SENSOR PROFILE—shows the sensor settings
compared to actual sensor readings. To interpret
the results of the sensor profile, see Sensor Profile
on page 149.
Related ZPL command(s):
Settings: ~WC
Network: ~WL
Sensor profile: ~JG
Others: ^WD
SGD command used: none
Control panel menu item:
Settings: PRINT INFORMATION on page 24
Network: PRINT INFORMATION on page 30
Sensor profile: PRINT INFORMATION on page 34
Control panel key(s):
Settings and Network: Do one of the following:
Hold CANCEL during printer power-up.
Hold FEED + CANCEL for 2 seconds when
the printer is in the Ready state.
Sensor profile: Hold FEED + CANCEL during
printer power-up.
Printer web page:
View and Modify Printer Settings >
Print Listings on Label