Filter
Top Products
12 Zoom AP+4 User Guide
Note
: To use the AP+4 as a repeater, we
recommend that you select AP and then select the
Enable
Universal Repeater Mode
check box at the
bottom of this page. Do not select WDS unless you
are sure you want to set up a WDS network.
!
AP+WDS
in the unlikely event that you want the
AP+4 to operate as both an Access Point and a
Repeater in WDS mode.
•
At
Network Type
(available only if the AP+4 is operating as
a Client) select Infrastructure (most users) or Ad Hoc.
•
At
SSID
(
S
ervice
S
et
ID
entifier), enter a network name. All
wireless devices on your network should use the same
name.
•
At
Channel Number
(available only if you selected Ad Hoc
channel as your Network Type), select a channel number
that isn’t being used by another nearby network. If you are
unsure which channel to use, try Channel 6.
•
Select
Enable MAC Clone
in the unlikely event that you
want to use the MAC address of a device in the network
instead of the AP+4’s MAC address.
•
Select
Enable Universal Repeater Mode
if you want to use
the AP+4 to extend the range of an existing wireless
network.
!
If you select Enable Universal Repeater Mode, at
SSID of Extended Interface
, enter the SSID
(network name) of the network to be extended. You
can normally get this SSID from the user interface of
the network’s router.
Click
Next
to continue.