Filter
Top Products
Chapter 1. Installing the AP+4 7
Connecting the Hardware
1
11
1
Put the AP+4 near a computer to be used for setup. That
computer needs an Ethernet (LAN) port.
2
22
2
Turn off the computer.
3
33
3
Connect one end of the supplied power cube to the AP+4
PWR
jack, and the other end to a live power source.
Important!
Only use the power cube shipped with the
AP+4. Other power cubes may damage the device.
The
PWR
LED on the AP+4 front panel should turn on and
the
WLAN
LED should flash. (The WLAN LED continues to
flash to signify broadcast activity as long as the Wireless
LAN is enabled. It is enabled by default.)
4
44
4
Connect one end of the supplied Ethernet cable to the
computer’s Ethernet port and the other end to one of the
AP+4’s LAN ports.
5
55
5
Turn on the computer.
The
WLAN
LED continues flashing and the connected
LAN
port and the
ACT
(Activity) LEDs become steady on. (If you
have a 10 Mbps Ethernet connection, the LAN LED does not
turn on.)
6
66
6
If you want the AP+4 to have access to the Internet, connect
its WAN port to the Ethernet port on your cable modem,
ADSL modem, or other broadband device.
The
WAN
LED turns on.