Filter
Top Products
Prestige 100WH Internet Access Router
3-2
Chapter 3 Internet Access Application
The General Setup menu allows you to define the filter sets that you wish to apply to your
Ethernet traffic. From Menu 3 - Ethernet Setup, enter 1 to go to Menu 3.1 -General Ethernet
Setup.
Figure 3-2. Menu 3.1 - General Ethernet Setup
Filters are not required for your Prestige to function properly. However, input and output filter
sets may be useful to block certain packets, reduce traffic, and prevent a security breach on
your Ethernet.
If you have a need for filters, read about Chapter 7 - Filter Set Configuration, then return to
this menu to define the appropriate filter sets.
3.2 TCP/IP Ethernet and DHCP Setup
3.2.1 IP Address and Subnet Mask
The Prestige is pre-configured in the factory with an IP address of 192.168.1.1 and a subnet
mask of 255.255.255.0 (Class C). This setup should work fine for the basic Internet access
application. It is strongly recommend that you do not change them, unless your ISP or
network administrator assigns you a block of registered IP addresses.
Menu 3.1 - General Ethernet Setup
Input Filter Sets=
Output Filter Sets=
Press ENTER to Confirm or ESC to Cancel: