Filter
Top Products
Prestige 304 Broadband Sharing Gateway with 4-Port Switch
2-4 Hardware Installation
2.2.4 LAN 10/100M Connections/Uplink Button Usage at a Glance
Table 2-2 Ethernet Cable Requirements for LAN 10/100M Port Connections
LAN 10/100M
PORT NUMBER
TYPE OF ETHERNET CABLE FOR CONNECTING THE
PRESTIGE TO A …
COMPUTER HUB
1 straight-through crossover
2 straight-through crossover
3 straight-through crossover
4
UPLINK
button “on”
straight-through crossover
4
UPLINK
button “off”
crossover straight-through
2.2.5 POWER 5VDC Port
Connect the female end of the power adapter to the port labeled POWER 5VDC on the rear panel of your
Prestige.
To avoid damage to the Prestige, make sure you use the correct power adapter.
Refer to the Power Adapter Specification Appendix for this information.
2.2.6 RESET Button
Refer to section 2.5 for information on the RESET button.
2.3 Additional Installation Requirements
1. A computer(s) with an installed Ethernet NIC (Network Interface Card).
2. A cable/xDSL modem and an ISP account.
2.4 Turning on Your Prestige
At this point, you should have connected the LAN port(s), the WAN port and the POWER port to the
appropriate devices or lines. Plug the power adapter into an appropriate power source.
The SYS LED turns on. The WAN LED and the LAN LED (s) turn on after the system tests are complete if
proper connections have been made to the LAN and WAN ports.