Filter
Top Products
ES-4124 User’s Guide
286 Chapter 42 Introducing Commands
passive-iface
<ip-addr/bits>
Sets the interface to be passive.
A passive interface does not send
or receive OSPF traffic.
13
rip
Enables and enters the RIP
configuration mode.
13
exit
Leaves the RIP configuration
mode.
13
vrrp network <ip-
address>/<mask-
bits> vr-id <1-7>
uplink-gateway
<ip>
Adds aa new VRRP network nd
enters the VRRP configuration
mode.
13
exit
Exits from the VRRP command
mode.
13
inactive
Disables the VRRP settings. 13
interval
<1..255>
Sets the time interval (in
seconds) between Hello
message transmissions.
13
name <name
string>
Sets a descriptive name of the
VRRP setting for identification
purposes.
13
no inactive
Activates this VRRP. 13
no preempt
Disables VRRP preemption
mode.
13
no primary-
virtual-ip
Resets the network to use the
default primary virtual gateway
(interface IP address).
13
no secondary-
virtual-ip
Sets the network to use the
default secondary virtual gateway
(0.0.0.0).
13
preempt
Enables preemption mode. 13
primary-
virtual-ip
<ip>
Sets the primary VRRP virtual
gateway IP address.
13
priority <1-
254>
Sets the priority of the uplink-
gateway.
13
secondary-
virtual-ip
<ip>
Sets the secondary VRRP virtual
gateway IP address.
13
service-
control
ftp <socket-
number>
Allows FTP access on the
specified service port.
13
http <socket-
number> <timeout>
Allows HTTP access on the
specified service port and defines
the timeout period.
13
https <socket-
number>
Allows HTTPS access on the
specified service port.
13
Table 107 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE