Filter
Top Products
ES-4124 User’s Guide
Chapter 42 Introducing Commands 289
42.11.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
Table 108 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-limit
Enables ingress (pir), cir and
egress limits on the port(s).
13
cir
Enables the guaranteed bandwidth
limits for incoming traffic on the
port(s).
13
cir <Kbps>
Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir
Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir <Kbps>
Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
egress
Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13
egress <Kbps>
Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
<peer|tunnel|di
scard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
broadcast-limit
Enables broadcast storm control
limit on the switch.
13
diffserv
Enables DiffServ on the port(s). 13
dlf-limit
Enables the Destination Lookup
Failure (DLF) limit.
13
<pkt/s>
Sets the interface DLF limit in
packets per second (pps).
13
egress set
<port-list>
Sets the outgoing traffic port list for
a port-based VLAN.
13
exit
Exits from the interface port-
channel command mode.
13
flow-control
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
13