Filter
Top Products
ES-4124 User’s Guide
Chapter 42 Introducing Commands 293
Use these commands to configure the IP routing domains.
Table 109 interface route-domain Commands
COMMAND DESCRIPTION
PRIVILEG
E
interface
route-domain
<ip-address>/
<mask-bits>
Enables a routing domain for
configuration.
13
exit
Exits from the interface routing-
domain command mode.
13
ip dvmrp
Enables this function to permit
VLAN groups beyond the local
switch.
13
igmp <v1|v2>
Enables IGMP in this routing
domain.
13
igmp robustness-
variable <2-255>
Sets the igmp robustness variable
on the switch. This variable
specifies how susceptible the
subnet is to lost packets.
13
igmp query-interval
Sets the igmp query interval on
the switch. This variable specifies
the amount of time in seconds
between general query messages
sent by the router.
13
igmp query-max-
response-time <1-25>
Sets the maximum time that the
router waits for a response to an
general query message.
13
igmp last-member-
query-interval <1-
25>
Sets the amount of time in
seconds that the router waits for a
response to a group specific
query message.
13
ospf authentication-
key <k>
Enables OSPF authentication in
this routing domain.
13
ospf authentication-
same-aa
Sets the same OSPF
authentication settings in the
routing domain as the associated
area.
13
ospf cost <1-65535>
Sets the OSPF cost in this routing
domain.
13
ospf message-digest-
key <k>
Sets the OSPF authentication key
in this routing domain.
13
ospf priority <0-
255>
Sets the OSPF priority for the
interface. Setting this value to 0
means that this router will not
participate in router elections.
13
rip direction
<Outgoing|In>
Sets the RIP direction in this
routing domain.
13
vrrp authentication-
key <k>
Sets the VRRP authentication key
in the routing domain.
13