Filter
Top Products
Chapter 17 Remote Management Configuration
P-660HWP-Dx User’s Guide
41
17.6.2 SNMP Traps
The P-660HWP-Dx will send traps to the SNMP manager when any one of the following
events occurs:
17.6.3 Configuring SNMP
To change your P-660HWP-Dx’s SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.
Figure 141 Remote Management: SNMP
Table 101 SNMP Traps
TRAP #
TRAP NAME DESCRIPTION
0 coldStart (defined in RFC-1215) A trap is sent after booting (power on).
1 warmStart (defined in RFC-1215) A trap is sent after booting (software reboot).
6 whyReboot (defined in ZYXEL-
MIB)
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
6a For intentional reboot: A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
6b For fatal error: A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.