Filter
Top Products
VSG-1200 User’s Guide
Chapter 3 The Web Configurator 47
3.6 System Login Accounts
There are four system accounts that you can use to log in to the VSG: administrator, account
manager, supervisor and super subscriber.
• The administrator account allows you full access to all system configurations. The default
administrator user name is “admin” and password “1234”.
Layer 2 Isolation
Security
If you activate NAT, select Enable in this field to prevent communication between
subscribers. This is the default selection.
Select Disable to deactivate layer 2 security and allow communication between
subscribers.
Console Type Use this field to set the function of the Console port on the front panel of the
VSG.Select Console Setting when you connect the console port directly to a
computer for local management. This is the default setting. Select Statement
Printer when you connect the console port to an SP-200.
Console Port Rate Select the fields below to configure the Console port.
Note: If you change the console port settings, make sure you also
make the same change to the terminal emulator software.
Bits per second This field only applies when you select Console Setting in the Console Type
field.
Select a console port speed from the drop-down list box. Choices are 1200, 2400,
4800, 9600, 14400, 19200, 38400, 57600 and 115200. The default selection is
9600.
Data bits Select a data bit from the drop-down list box.
Parity Select the parity from the drop-down list box.
Stop bits Select the stop bit from the drop-down list box.
Administrator
Authorized Access
IP Address
Select Any to use any computer to access the web configurator on the VSG.
Select Specify and then enter the IP address(es) or a range of IP addresses of the
computer(s) that is allowed to log in to configure the VSG.
Multicast Pass
Through
Select Enable to allow multicast traffic to pass through the VSG. This may affect
your network performance.
Select Disable to prevent any multicast traffic from passing through the VSG. This
is the default setting.
Allow remote user
to ping the device
Select Enable to respond to Ping requests from the LAN or WAN interface.
Select Disable to not respond to Ping requests from the LAN or WAN interface.
SSL Certificate Certificate Secure Socket Layer (SSL) security allows you to create a secure
connection between the VSG and the client computer(s).
Select Default to use the default system-generated SSL certificate.
Select Custom Certificate to use a certificate obtained from a certificate authority.
Refer to Chapter 25, “Secure Socket Layer,” on page 189 for more information.
Apply Click Apply to save the changes.
Table 3 System Setting: System (continued)
LABEL DESCRIPTION