following command to restart the SSH server on the default VRF: ip ssh server
vrf.
Example
• Dell(conf)#ip ssh server vrf vrf1
• Dell(conf)#no ip ssh server vrf
• Dell(conf)#ip ssh server vrf management
• Dell(conf)#no ip ssh server vrf
Related
Commands
show ip ssh — displays the ssh information.
ip ssh source-interface
Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
1436
Security
