logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging
source-interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1. The port range
is 0.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Simple Network Management Protocol (SNMP) and Syslog
1515
