NOTE: This command supports Loopback interfaces EE3 and EF series route
processor modules (RPMs). This command does not support Loopback
interfaces ED series RPMs and S-Series Loopback interfaces.
NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies
only for routed traffic egressing out of that port.
To associate an access-list to a non-default VRF, use the vrf attribute of this
command. You can use this command at the interface context (physical/LAG) to
apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — configures an extended ACL.
ip control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of filters.
Syntax
show ip accounting {access-list access-list-name | cam_count}
interface interface [vrf vrf-name]
Parameters
access-list-
name
Enter the name of the ACL to be displayed.
cam_count List the count of the CAM rules for this ACL.
interface
interface
Enter the keyword interface then the one of the following
keywords and slot/port or number information:
188
Access Control Lists (ACL)
