redundancy protocol
Enable hitless failover for a protocol.
Syntax
redundancy protocol
Protocols
lacp Enter the LACP protocol
xstp Enter one of the following protocols: STP, RSTP, MSTP,
PVST.
Defaults Not enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the members option.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax
reset stack-unit <0–5> hard
Parameters
stack-unit Enter the stack-unit number. For the S6000, the range is
from 0 to 5.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1532
Stacking
