Tripp Lite B070-016-19-IP Manual

next previous

2. Web Conﬁguration Interface

•Obtain DNS Server Address Automatically –WhentheDHCPmodecheckboxischecked,thischeckboxisalsochecked.

 WhentheStatelessorStaticmodecheckboxesarechecked,thischeckboxisdeactivated,andyoumustmanuallyentera 

 DNSServeraddress.

•DNS Server–WheninDHCP mode, check the checkbox next to DNS Servertomanuallyassignitsaddress.Whenthe 

Stateless or Static mode checkboxes are checked, the Obtain DNS Server Address Automatically checkbox is deactivated,

and you must manually enter a DNS Serveraddress.EnteraDNSServeraddressappropriateforyournetwork.

•AftermakinganychangestotheKVM’sLANsettings,clickontheSave button at the top of the screen to save them. Upon

clicking Save, you will be prompted to reboot the KVM to ﬁnish implementation of the new Device settings.

Click Yes to proceed.

Conﬁguring the SNMP settings:

ThissectionoftheDevicetaballowsyoutoconguretheKVMsothatnoticationscanbesenttoaSNMPserverwhenaLAN

portfails.Uponreceivingnoticationofthefailure,LANredundancyisenabled.Note: If both LANs fail, a message cannot be

sent to the SNMP server.

•Trap Recipient Address – The Trap Recipient Address section provides three types of addresses that you can enter for the

 SNMPserverthatyouwanttrapstobesentto:IPv4, IPv6, and Host. Check the checkbox of the type of address you wish to

 enter,andthenenterintheaddressthatcorrespondstoyourSNMPserver.

•Community –Inthiseld,typeintheSNMPwritecommunitystringtobeusedforauthenticationofmessagessent 

 betweentheKVMandtheSNMPserver.

•AftermakinganychangestotheKVM’sSNMP settings, click on the Save button at the top of the screen to save them.

Upon clicking Save, you will be prompted to reboot the KVM to ﬁnish implementation of the new Device settings.

Click Yes to proceed.

2.4.5 Users

The Users tab in the Conﬁguration section allows administrators to Add, Edit, and Delete accounts on the KVM. Up to 256 accounts can be

added, with any combination of Administrators and Users. The following section describes this page, and how to conﬁgure accounts.

Therearetwolevelsofuseraccess:

• Administrator – Hasunrestrictedaccesstoallwindowsandsettings,andcanchangethenameandpasswordofallusers.

• User – Can access and control Target Servers that they are given access to by an administrator. Users cannot access the Conﬁgure or

Events sectionsoftheWebCongurationInterface,norcantheydisconnectremotesessions.Wheninaremotesession,theyarenot

allowed to access the power management functionality.