Filter
Top Products
Declaration of Conformity 119
HomePortal 3801HGV Gateway User Guide Regulatory Information
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
m Changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate this equipment.
TIA 968 (Part 68 of FCC Rules) / IC CS-03
This equipment complies with the Telecommunication Industry Association TIA-968 (FCC part 68) and
Industry Canada CS-03 Telecommunication requirements. On the product is a label that contains,
among other information, the IC and FCC registration number and ringer equivalence number (REN) for
this equipment. If requested, this information may be provided to the telephone company.
The REN is used to determine the quantity of devices that may be connected to the telephone line.
Excessive RENs on the telephone line may result in the device not ringing in response to an incoming
call. In most, but not all areas, the sum of the RENs should not exceed five (5.0) / L’indice
d’équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de terminaux qui peuvent être
raccordés à une interface téléphonique. La terminaison d’une interface peut consister en une
combinaison quelconque de dispositifs, à la seule condition que la somme d’indices d’équivalence de
la sonnerie de tous les dispositifs n’excède pas 5.
To be certain of the number of devices that may be connected to the line, as determined by the total
RENs, contact the telephone company to determine the maximum RENs for the calling area.
This product cannot be used on telephone-company-provided coin service. Connection to Party Line
Service is subject to state tariffs.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack
that is Part 68 compliant. If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service may be required. If
advance notice is not practical, the telephone company will notify the customer as soon as possible.
Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The
telephone company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of this equipment. If this happens, the telephone company will provide advance
notice in order for you to make the necessary modifications to maintain uninterrupted service. If trouble
is experienced with this equipment, please contact 2Wire, or your local 2Wire distributor or service
center in the U.S.A. for repair and/or warrant information. If the trouble is causing harm to the
telephone network, the telephone company may request you to remove this equipment from the
network until the problem is resolved. No repairs can be done by a customer on this equipment. It is
recommended that the customer install an AC surge arrestor in the AC outlet to which this device is
connected. This is to avoid damage to the equipment caused by local lightning strikes and other
electrical surges.
MPE/SAR/RF Exposure Information
This device was verified for RF exposure and found to comply with Council Recommendation 1999/
519/EC and FCC OET-65 RF exposure requirements. This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment.
c While this device is in operation, a separation distance of at least 20 cm (8 inches) must
be maintained between the radiating antenna inside the EUT and the bodies of all persons