Filter
Top Products
Before Installing Drivers 8-3
TokenDisk Diskette #2 Contents
TokenDisk diskette #2 contains the NDIS 4 miniport
driver for Windows 95 and Windows NT. This driver is
enabled for DynamicAccess Class of Service. Follow the
instructions in Chapter 4, “Installing a Network Driver for
Windows 95,” or Chapter 6, “Installing a Network Driver
for Windows NT,” to install this driver.
To obtain drivers for network operating systems not
included on the TokenDisk diskettes, contact the network
operating system (NOS) manufacturer or use the IBM
drivers supplied with the NOS.
For a list of supported drivers, software driver updates,
and patches for the drivers on the TokenDisk diskettes,
refer to the 3Com online delivery services listed in
Appendix B, “Technical Support.”
Before Installing Drivers
The 3C319 NIC must be installed in the PC, as described
in Chapter 2, “Installing the 3C319 NIC.”
The drivers described in this chapter are not
PnP-enabled. Before installing a driver, be sure to
disable PnP and manually configure the NIC using the
procedures described in Chapter 5, “Configuring the
NIC Manually.”
Installing the Client Driver for NetWare
If you did not use the AutoLink configuration utility,
follow these steps to install the DOS ODI client driver
for NetWare:
1 Make sure the 3C319 NIC is configured as described
in Chapter 5, “Configuring the NIC Manually.”
2 Start the Install program on TokenDisk diskette #1.
3 From the main menu shown in Figure 8-1, select
Driver Installation and Update... and press [Enter].