Filter
Top Products
Downloading Software Release 1.1 23
When the upgrade is complete, the following message will appear:
Downloaded Image File Check OK!!
Update FlashROM Image at 0x030C0000 ... SUCCESS !
The Switch will then automatically reboot.
Loading Software via XModem Using the Console Interface
You can upgrade system firmware (Runtime or POST) by connecting a
computer to the serial port on the Switch and using a terminal emulation
program that supports the XModem protocol. (See the Switch 4005
Installation and Maintenance Guide for the required connections.)
1 Initialize any terminal emulation program that supports the XModem
protocol, such as Windows HyperTerminal.
a Start the terminal emulation program.
b Specify the port attached to the Switch, such as COM2.
c Set the baud rate to 9600 bps.
d Disable Flow Control.
e Press OK
2 Restart the system by using the
System Control Reboot command, or by
pulling out the power cord to reset the power, waiting five seconds, and
plugging it back in.
3 When the system initialization screen appears as shown below, press “D”
to download system firmware. You have less than 10 seconds to choose
the Download option. After this delay, the system will automatically start
the console interface program.
(c)2001 3COM Corporation
Switch 4005
LOADER Version V1.00
POST Version V1.00
------ Performing the Power-On Self Test (POST) ------
EPROM Checksum Test ....................... PASS
Testing the System SDRAM .................. PASS
CPU Self Test ............................. PASS
EEPROM Checksum Test ...................... PASS
MAC Address .............. 00-E0-29-9F-35-21
------------ Power-On Self Test Completed ------------
(D)ownload System Image or (S)tart Application: [S]D