3Com 4005 Switch User Manual


 
3
RELEASE ISSUES FOR INTERFACE
MODULES
This chapter addresses issues for Interface Modules for the software
releases noted in Table 1 on page 5. The topics in this chapter are:
Operating Considerations
Known Problems
Operating
Considerations
This section describes operating considerations that apply to Interface
Modules at this release.
System
You cannot stage a module in one chassis and then move that module
to another chassis, because port mapping is based on the module’s
hardware identifier.
The 10/100BASE-TX ports on the 3C16828 Fast Ethernet module may
not autonegotiate with a SUN Ultra 2 10/100BASE-TX Ethernet card. If
traffic is sent from the SUN during autonegotiation, then
autonegotiation completes successfully.
The Switch 4005 does not support Strict Source Routing or ICMP
Redirection.
Module NVdata
You cannot restore the nonvolatile data (NVdata) configuration from
one Switch 4005 interface module to another.
SNMP
To prevent timeouts of SNMP requests, 3Com recommends that you
increase the default timeout for the network management station.
SNMP response time may vary depending on the current network
load.