Filter
Top Products
44 Chapter 3: Starting and Configuring the Router 5000
Setting terminal parameters Follow these steps to set the
parameters of the Hyper Terminal in Windows98:
1 Select a connection port.
Select the serial interface to be connected in the [Connect using] box, as
shown in Figure 32. Please note that the selected serial interface should
be consistent with the actual serial interface connected by the console
cable.
Figure 32 Setting the connection port in the local configuration
2 Set the serial interface parameters. As shown in Figure 33, in the
properties dialog box of the serial interface, set the baud rate to 9600,
data bit to 8, no parity check, stop bit to 1, and flow control to none.
Then, click <OK> to return to the HyperTerminal window.