Filter
Top Products
46 Chapter 3: Starting and Configuring the Router 5000
Checking/operating after power-on
After the router is powered on, please perform the following inspection.
1 Whether the LEDs on the front panel are normal
■ In the process of the Power On Self Test (POST), the LEDs light in the
following sequence: SLOT1 to 3 are ON first. Then, if SLOT 2 and 3 are
ON, it means that the memory test is successful. If SLOT 1 and 2 are
ON, it indicates the failure of the memory test.
■ For the status of the LEDs during normal operation after power-on,
please refer to Chapter 2 System Specifications.
2 Whether the console terminal display is normal
The startup interface on the console terminal can be seen after the router
is powered on (see “Startup Process” below).
After the startup (in other words, self-test), the user is prompted to press
<Enter>. When “<3Com>” is displayed, the user can proceed to
configure the router.
Startup Process The Router 5000 use the same version of Boot ROM program.
After the startup of the router, Boot ROM program will be run first and
the following system information will be displayed on the terminal
screen:
The interfaces displayed on the terminal may vary slightly with different
versions of Boot ROM.
Router start booting,(V2.00)
Starting at 0x1500000...
********************************************
* *
* 3Com Router 5000 Boot ROM, V9.19 *
* *
********************************************
Compiled at 12:17:34 , Jul 19 2005.
Testing memory...OK!
256M bytes SDRAM
32768k bytes flash memory
Hardware Version is MTR 1.0
CPLD Version is CPLD 1.0
Press Ctrl-B to enter Boot Menu