Filter
Top Products
3 - 16 ONline Ethernet 24-Port 10BASE-T Module Installation Guide
4. Replace the small screw in the top screw hole of the 50-pin cable
connectors to secure the cables to the module connectors as shown
in Figure 3-5.
Note: Do not overtighten the top screw on either connector.
Over tightening the top screw can cause the bottom part
of the connector to lift and disconnect the lower pins on
the cable from the lower pins on the module connector.
5. Wrap the tie-wrap around the cable connector to secure the cable
connector to the module connector (see Figure 3-6). Do not fasten
the tie-wrap around the module ejectors.
Figure 3-6. Attaching Cables With 90° Connectors