Filter
Top Products
Installing and Operating the Module 3 - 21
SET MODULE {
slot
} NETWORK {ethernet_1}
{ethernet_2}
{ethernet_3}
{isolated}
To assign a specific connector (bank of 12 ports) to a network, use the
following management command:
SET MODULE {
slot
} CONNECTOR_{1}_NETWORK {ethernet_1}
{2} {ethernet_2}
{ethernet_3}
{isolated_1}
{isolated_2}
Note: Assigning one connector to ISOLATED_1 and the other
connector to ISOLATED_2 creates two isolated 12-port
subnetworks. Assigning both connectors to the same
isolated network creates a single 24-port isolated network.
Enabling Remote Diagnostics Mode
When used with a 3Com Fault-Tolerant 10BASE-T Transceiver, remote
diagnostics mode allows the 24-Port Module to detect certain unusual
failure conditions (including disruption of single wires in the twisted pairs).
Refer to the Fault-Tolerant 10BASE-T Transceiver Installation Guide for
more information on this feature.
To enable remote diagnostics mode for a specific port, use the following
management command:
SET PORT {
slot.port
} MODE {remote_diagnostics} {
slot.port
}
{non_remote_diagnostics}