3Com WL-455 Network Card User Manual


 
46
f WPA Key Management set to WPA Authentication over 802.1x.
g Click on Apply.
11 The Access Point is now configured for WPA Authentication over 802.1x.
HOW TO SETUP THE ACCESS POINT FOR WPA WITH
PRE-SHARED (PSK) KEY
1 Using the Wireless Infrastructure Device Manger access the configuration screen
for the AP8x00/AP82x0.
2 Enter your User Name and Password and click LOGIN (Default: admin with no
password).
3 Select Advanced Setup.
4 Choose Authentication from the left frame page Menu.
5 Make sure the following settings are set on the Authentication page:
aMAC Authentication is Disabled. (if Local or RADIUS MAC Authentication
is chosen MAC address filtering or authentication, respectively, will be done
before the 802.1x authentication. Therefore, these setups must be validated
individually and verified functional before 802.1x can be done).
b 802.1x Wireless Setup: is set to Disabled or Optional (if RADIUS clients need
access too).
c Click on Apply.
6 Click Security on the 802.11a/b/g radio from the left frame page Menu.
7 Make sure the following settings are set from the Security page:
a Authentication is set to Open System.
b Encryption is Enabled.
c WPA Configuration is Checked to “Allow only WPA Clients”.
d Cipher Mode is set to AES/TKIP/WEP (WEP Cipher Mode is intended ONLY
for support of legacy clients. If only WPA clients are on the network, choose
AES or TKIP for increased security).
e WEP Configuration has at least one valid WEP key (select the appropriate key
length, key type, and key index).
f WPA Key Management select WPA Pre-shared Key (PSK) and Key Type.
gEnter the WPA PSK.
h Click on Apply.
8 The Access Point is now configured for WPA Pre-shared Key.