Filter
Top Products
51
While you are configuring the
access point, the Configuration
Management System stops
responding.
To maintain wireless association, the service area and the
security settings on the client and the access point must
match exactly. Therefore, if you are associated with the
access point that you are configuring and you change the
access point service area or security, make sure to change the
client service area to match.
If you change the IP address and save the change, you cannot
continue to configure the access point using the old IP
address. Therefore, if you want to continue configuring this
access point after you save this change, you must do the
following:
1 Close your browser.
2 Return to the 3Com Device Manager Wireless Network
Tree and click Refresh.
3 Select the access point and click Configure to start a new
configuration session.
The access point cannot be
configured using the Web
browser.
Reset the access point (push the reset button located on the
rear panel of the access point).
Symptom Solutions