Filter
Top Products
65
While you are configuring
the access point, the
Configuration Management
System stops responding.
To maintain wireless association, the service area and the
security settings on the client and the access point must
match
exactly. Therefore, if you are associated with the
access point that you are configuring and you change
the access point service area or security, make sure to
change the client service area to match.
If you change the IP address and save the change, you
cannot continue to configure the access point using the
old IP address. Therefore, if you want to continue
configuring this access point after you save this change,
you must do the following:
1 Close your browser.
2 Return to the 3Com Device Manager Wireless
Network Tree and click Refresh.
3 Select the access point and click Configure to start a
new configuration session.
The access point cannot be
configured using the Web
browser.
Reset the access point (push the reset button located
near the access point LEDs).
Symptom Solutions