Filter
Top Products
326 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Examples — The following command creates a profile for automatic
Distributed MAP configuration:
WX1200# set dap auto
success: change accepted.
See Also
set dap auto mode on page 327
set dap auto radiotype on page 326
set {ap | dap} bias on page 328
set {ap | dap} blink on page 330
set {ap | dap} group on page 332
set {ap | dap} radio auto-tune max-power on page 335
set {ap | dap} radio auto-tune max- retransmissions on page 337
set {ap | dap} radio auto-tune min-client-rate on page 340
set {ap | dap} radio mode on page 341
set {ap | dap} radio radio-profile on page 343
set {ap | dap} upgrade-firmware on page 346
set dap auto
radiotype
Sets the radio type for single-MAP radios that use the MAP configuration
profile.
Syntax —
set dap auto [radiotype {11a | 11b| 11g}]
radiotype {11a | 11b| 11g} — Radio type. (The 11a option
applies only to single-radio models. The 802.11a radio in two-radio
models is always 802.11a.):
tx-pwr Highest setting allowed for the
country of operation
radio-profile (profile) default
max-power default
min-client-rate 5.5 for 802.11b/g
24 for 802.11a
max-retransmissions 10
Table 65 Configurable Profile Parameters for Distributed MAPs (continued)
Parameter Default Value