Filter
Top Products
88 CHAPTER 4: PORT COMMANDS
Examples — The following command disables PoE on ports 4 and 5,
which are connected to a MAP access point:
WX1200# set port poe 4,5 disable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
The following command enables PoE on ports 4 and 5:
WX1200# set port poe 4,5 enable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
See Also
set port type ap on page 91
set port type wired-auth on page 94
set port preference Configures a gigabit Ethernet port on a WX4400 to use the RJ-45
(copper) interface, when available, as the active link instead of the fiber
interface.
Syntax —
set port preference port-list rj45
port-list — List of physical ports. MSS sets the preference on all the
specified ports.
rj45 — Prefers the copper interface.
Defaults — When both the copper and fiber interfaces of a gigabit
Ethernet port are connected, the GBIC (fiber) interface is the active link.
The RJ-45 (copper) link is unused.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400.
If you set the preference to RJ-45 (copper) on a port that already has an
active fiber link, MSS immediately changes the link to the copper
interface.